EN
GET A QUOTE
Home Biodiesel Feedstock

Biodiesel Feedstock Pre-Treatment Solutions

Jiangsu Sunrise helps biodiesel producers handle used cooking oil, animal fat and oil-rich feedstock with lamella pump and fat press equipment, supporting material transfer and oil or fat recovery where applicable.

Contact Our Team
Feedstock Streams

Biodiesel Feedstock Streams from Waste Oils and Animal Fats

Biodiesel feedstock can come from many waste-to-resource streams, but these materials often contain water, fine solids, food residues, sludge, gums or other impurities. Sunrise recommends suitable transfer or pressing equipment according to the source, impurity level, oil content, viscosity and target feedstock quality.

  • Used cooking oil from restaurants and food processors
  • Waste vegetable oil from edible oil and food industries
  • Recovered animal fat from rendering operations
  • Tallow, grease and mixed fat streams
  • Oil-rich mixtures from waste oil collection
  • Oily sludge with recoverable fat or oil
  • Low-grade oil streams requiring transfer, conditioning or pressing support
Pre-Treatment Goals

Oil Recovery and Feedstock Handling Support

Improve biodiesel feedstock handling by supporting transfer, conditioning and oil or fat recovery before further processing.

Feedstock Quality Improvement

Improve biodiesel feedstock consistency by removing water, sludge, suspended solids and visible impurities before further processing.

Feedstock Handling Support

Support stable handling of used cooking oil, animal fat and mixed waste oil streams before downstream biodiesel production.

Residue Handling

Handle food residues, fine particles, sludge and organic solids that can affect storage, pumping and processing efficiency.

Recovered Oil and Fat Utilization

Recover usable oil and fat from mixed waste streams instead of sending valuable material to disposal or low-value treatment.

Lower Waste Treatment Load

Reduce the amount of oily wastewater, sludge and unstable residues entering downstream environmental treatment systems.

Cleaner Renewable Fuel Supply Chain

Support a more circular biodiesel feedstock process by upgrading waste fats and oils before they become renewable fuel raw material.

Pre-Treatment Process

Typical Biodiesel Feedstock Pre-Treatment and Oil Separation Process

A biodiesel feedstock pre-treatment setup is usually designed around the condition of the incoming waste oil or fat. Materials with high viscosity, high solids content or mixed oil-rich phases may require heating, conditioning, transfer pumping and pressing support before they are suitable for further biodiesel processing.

  • Waste oil or fat receiving
  • Heating or conditioning
  • Transfer pumping
  • Coarse solids removal
  • Pressing support where applicable
  • Recovered oil or fat collection
  • Residue discharge
  • Prepared feedstock to storage or further biodiesel processing
Environmental Benefits

Waste Oil to Biodiesel Feedstock: Environmental and Recovery Benefits

Used cooking oil, animal fat and waste vegetable oil can become valuable biodiesel feedstock when unstable residues are properly handled before downstream processing. Without effective pre-treatment, these waste streams may increase sludge volume, wastewater load, odor risk and processing difficulty.

Sunrise lamella pump and fat press equipment helps handle oil-rich materials, recover useful oil or fat where applicable and make waste-derived biodiesel feedstock more stable. This supports a cleaner waste-to-resource pathway for biodiesel producers, rendering plants, edible oil processors and waste oil collectors.

Custom System

Custom Pre-Treatment for Waste Oil Streams

Different biodiesel feedstock sources behave differently during handling and recovery. Sunrise evaluates the actual waste oil or fat stream before recommending suitable lamella pump or fat press equipment.

  • Feedstock Source

  • Water Content

  • Solids and Sludge Content

  • Oil or Fat Recovery Target

  • Temperature and Viscosity

  • Daily Processing Capacity

  • Downstream Biodiesel Process

Tell Us Your Feedstock and Tonnage.

We Engineer the Line.

From a single fat press to a full continuous rendering plant — speak with our engineering team about a tailored configuration for your site.

TALK to Our experts